CHAPTER
4-1
Cisco SCE8000 10GBE Installation and Configuration Guide
OL-21054-04
4
Installing the Cisco SCE8000 Chassis
Revised: November 8, 2010, OL-21054-04
Introduction
This chapter describes how to install a Cisco SCE8000 chassis.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
There is the danger of explosion if the battery is replaced incorrectly. The battery is not a
user-serviceable part.
Statement 1015
Warning
Class 1 laser product.
Statement 1008
Warning
Because invisible laser radiation may be emitted from the aperture of the port when no cable is
connected, avoid exposure to laser radiation and do not stare into open apertures.
Statement 1056
Warning
Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029
Note Before you install, operate, or service the system, read the Regulatory Compliance and Safety
Information for the Cisco SCE8000 Platform. This guide contains important safety information you
should know before working with the system.
To Next Page
Need help?
General
