Cisco SCE8000 Installing

4-2
Cisco SCE8000 10GBE Installation and Configuration Guide
OL-21054-04
Chapter 4 Installing the Cisco SCE8000 Chassis
Preparing for Installation
Caution Before working on a chassis or working near power supplies, unplug the power cord on AC units;
disconnect the power at the circuit breaker on DC units.
Note The plug-socket combination must be accessible at all times because it serves as the main disconnecting
device.
Note This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security.
• Preparing for Installation, page 4-2
• Installing the Cisco SCE8000 Chassis in the Rack, page 4-14
• Connecting the System Ground, page 4-19
• Installing the Power Supplies in the Cisco SCE8000 Chassis, page 4-20
Preparing for Installation
• Safety, page 4-2
• Site Requirements, page 4-3
• Power Connection Guidelines, page 4-5
Safety
Warning Read the installation instructions before connecting the system to the power source.
Note This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available.
Note This product requires short-circuit (overcurrent) protection, to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations.

Cisco SCE8000 Specifications

General

Brand	Cisco
Model	SCE8000
Category	Network Hardware
Language	English