EasyManuals Logo
Home>Cisco>Network Hardware>SCE8000

Cisco SCE8000 Installing

Cisco SCE8000
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
4-16
Cisco SCE8000 10GBE Installation and Configuration Guide
OL-21054-04
Chapter 4 Installing the Cisco SCE8000 Chassis
Installing the Chassis Brackets
Installing the Chassis Brackets
The chassis is shipped with the mounting brackets installed on the front of the chassis. These brackets
can be installed on the rear of the chassis.
To install the brackets on the rear of the chassis, perform these steps:
Step 1 Remove the screws that secure the brackets to the chassis. (See Figure 4-13.)
Figure 4-13 Brackets on Cisco SCE8000 Chassis
Step 2
Position one of the brackets against the chassis side, and align the screw holes.
Step 3 Secure the bracket to the chassis with the screws removed in Step 1.
Step 4 Repeat Step 2 and Step 3 for the other bracket.
Installing the Chassis in the Rack
Caution To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the
handles on modules (such as power supplies, fans, or cards); these types of handles are not designed to
support the weight of the unit. Lift the unit only by grasping the chassis underneath its lower edge.

Other manuals for Cisco SCE8000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SCE8000 and is the answer not in the manual?

Cisco SCE8000 Specifications

General IconGeneral
BrandCisco
ModelSCE8000
CategoryNetwork Hardware
LanguageEnglish

Related product manuals