Cisco SG100D-08 Unmanaged Gigabit Switch Quick Start Guide 6
STEP 3 Insert a screw into each hole, leaving a gap between the surface
and the base of the screw head of at least 0.1 inches (3 mm).
STEP 4 Place the unmanaged switch wall-mount slots over the screws and
slide the unmanaged switch down until the screws fit snugly into
the wall-mount slots.
STEP 5 Connect the unmanaged switch to the other devices, as described
in the “Connecting the Equipment” section.
Flat Surface Installation
To deploy the device on a desktop or other flat surface:
STEP 1 Place the unmanaged switch on a desktop near an AC power
source.
STEP 2 Connect the unmanaged switch to the other devices, as described
in the “Connecting the Equipment” section.
To Next Page
Loading...
Need help?
General
