Smartport
Default Configuration
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 182
10
Default Configuration
Smartport is always available. By default, Auto Smartport is enabled by Auto Voice VLAN,
relies on both CDP and LLDP to detect attaching device's Smartport type, and detects
Smartport type IP phone, IP phone + Desktop, Switch, and Wireless Access Point.
See Voice VLAN for a description of the voice factory defaults.
Relationships with Other Features
Auto Smartport is enabled by default and may be disabled. Telephony OUI cannot function
concurrently with Auto Smartport, and Auto Voice VLAN. Auto Smartport must be disabled
before enabling Telephony OUI.
Common Smartport Tasks
This section describes some common tasks to setup Smartport and Auto Smartport.
Workflow1: To globally enable Auto Smartport on the device, and to configure a port
with Auto Smartport, perform the following steps:
STEP 1 To enable the Auto Smartport feature on the device, open the Properties page. Set
Administrative Auto Smartport to Enable or Enable by Voice VLAN.
STEP 2 Select whether the device is to process CDP and/or LLDP advertisements from connected
devices.
STEP 3 Select which type of devices are to be detected in the Auto Smartport Device Detection field.
STEP 4 Click Apply
STEP 5 To enable the Auto Smartport feature on one or more interfaces, open the Interface Settings
page.
STEP 6 Select the interface, and click Edit.
STEP 7 Select Auto Smartport in the Smartport Application field.
STEP 8 Check or uncheck Persistent Status if desired.
STEP 9 Click Apply.
To Next Page
Loading...
Need help?
General
