Cisco SG550XG-24T User Manual

SNMP
Notification Recipients
373 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
21
NOTE If the Auto option is selected, the system takes the source IP address from the IP
address defined on the outgoing interface.
STEP 3 Click Add.
STEP 4 Enter the parameters.
• Server Definition—Select whether to specify the remote log server by IP address or
name.
• IP Version—Select either IPv4 or IPv6.
• IPv6 Address Type—Select either Link Local or Global.
- Link Local—The IPv6 address uniquely identifies hosts on a single network link. A
link local address has a prefix of FE80, is not routable, and can be used for
communication on the local network only. Only one link local address is supported.
If a link local address exists on the interface, this entry replaces the address in the
configuration.
- Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface—If the IPv6 address type is Link Local, select whether it is
received through a VLAN or ISATAP.
• Recipient IP Address/Name—Enter the IP address or server name of where the traps
are sent.
• UDP Port—Enter the UDP port used for notifications on the recipient device.
• Notification Type—Select whether to send Traps or Informs. If both are required, two
recipients must be created.
• Timeout—Enter the number of seconds the device waits before re-sending informs.
• Retries—Enter the number of times that the device resends an inform request.
• Community String—Select from the pull-down the community string of the trap
manager. Community String names are generated from those listed in the Communities
page.
• Notification Version—Select the trap SNMP version.
Either SNMPv1 or SNMPv2 may be used as the version of traps, with only a single
version enabled at a time.
• Notification Filter—Select to enable filtering the type of SNMP notifications sent to
the management station. The filters are created in the Notification Filter page.

Cisco SG550XG-24T Specifications

General

Brand	Cisco
Model	SG550XG-24T
Category	Switch
Language	English