Cisco TelePresence IX5200 First-Time Setup

6
Cisco TelePresence IX5000 and IX5200 First-Time Setup
OL-27038-01
Configuring Cisco Unified Communications Manager for Your Cisco TelePresence System
Tip For an IX5200, configure the device type as Cisco TelePresence IX5000 (18 seats).
Step 2 Load the Cisco TelePresence Administration Software image on the Unified CM server.
Note If your Unified CM has already loaded the required IX5000 software, you can skip this step.
Step 3 Add your system as a device in Unified CM. For more information, refer to the “Adding an IX System
to Unified CM” section in the Configuring Cisco Unified Communications Manager for the IX System
document.
Step 4 Add the TFTP server(s) used by the Unified CM server to your system using the IX System
administration GUI. Complete the following steps:
a. Log into the IX System administration GUI for your system as user admin. The default password is
cisco.
b. Click the Configuration icon (the gear on the left of the screen).
c. Scroll down to the Call Control Manager section.
d. Enter the TFTP Server(s) in the Call Control Manager area.
e. Click Apply.
For more information about configuring Unified CM with your Cisco TelePresence device, refer to the
Configuring Cisco Unified Communications Manager for the IX System document.
Finding the MAC Address for Your System
You need the codec MAC address to configure your system in Unified CM. There are two MAC
addresses on the codec. Use the address that is nearest the Uplink and EX1 Ethernet connections.
Figure 1 provides an example.
Tip You can also find this address on the blue screen while your system is booting up.

Cisco TelePresence IX5200 Specifications

General

Brand	Cisco
Model	TelePresence IX5200
Category	Conference System
Language	English