Cisco UCS C22 M3 High-Density SFF Rack-Mount Server
6
BASE SERVER STANDARD CAPABILITIES and FEATURES
BASE SERVER STANDARD CAPABILITIES and FEATURES
Tab le 1 lists the capabilities and features of the base server. Details about how to configure the server for
a particular feature or capability (for example, number of processors, disk drives, or amount of memory)
are provided in
CONFIGURING the SERVER, page 9.
Table 1 Capabilities and Features
Capability/Feature Description
Chassis Single rack unit (1RU) chassis
CPU One or two Intel® Xeon E5-2400 v2 or E5-2400 series processor family CPUs
Chipset Intel C600 chipset
Memory 12 DIMM slots
NIC Embedded dual-port Intel I350 PCIe-based Gigabit Ethernet controller
Expansion slots Two riser cards with one PCIe card slot in each riser
■ Riser 1 (controlled by CPU 1)
• Slot 1: PCIe Gen 3 slot, x16 extended connector (Cisco CNIC),
half-length, full-height, with NCSI
1
and Cisco CNIC
2
support. The
Cisco 1225 virtual interface card requires an NCSI slot.
■ Riser 2 (controlled by CPU 2)
• Slot 2: PCIe Gen 3 slot, x8 connector, half-length, half-height, no
NCSI support
Internal storage devices ■ Up to eight 2.5-inch SAS+SATA hot-swappable hard disk drives (HDDs) or
solid state drives (SSDs)
■ One connector on the motherboard that can accommodate a USB 2.0
drive. You can order an 8 GB drive for this connector and use it as a
hypervisor or license dongle. The 8 GB USB drive comes blank. Or, you
can order a 16 GB drive that contains preloaded drivers and utilities.
Video The Emulex Pilot 3 Integrated Baseboard Management Controller provides
video:
■ Matrox G200e video controller
■ Integrated 2D graphics core with hardware acceleration
■ Supports all display resolutions up to 1920 x 1200 x 16 bpp resolution at
60 Hz
■ 24-bit color depth for all resolutions less than 1600x1200
■ 256 MB video memory
To Next Page
Loading...
Need help?
General
