Physical Drives Changed State to Unconfigured Good
This section is applicable to E-Series Servers and the SM E-Series NCE. This section is not applicable to
the EHWIC E-Series NCE.
Note
This problem can occur if during bootup, at LSI OpROM, you concurrently entered wrong or empty pass
phrase three times. Because of the “BIOS Continue on Error” feature, the booting process continues, but the
drives cannot be accessed.
To resolve this problem, do the following:
1
Reboot the system, and then enter the correct pass phrase.
2
From LSI WebBIOS, configure the new pass phrase or remove security.
Cannot Access Secure Drives
This section is applicable to E-Series Servers and the SM E-Series NCE. This section is not applicable to
the EHWIC E-Series NCE.
Note
This problem can occur if during bootup, at LSI OpROM, you concurrently entered wrong or empty pass
phrase three times. Because of the “BIOS Continue on Error” feature, the booting process continues, but the
drives cannot be accessed.
To resolve this problem, do the following:
1
Reboot the system, and then enter the correct pass phrase.
2
From LSI WebBIOS, configure the new pass phrase or remove security.
Cannot Reconfigure Drives
This section is applicable to E-Series Servers and the SM E-Series NCE. This section is not applicable to
the EHWIC E-Series NCE.
Note
This problem can occur if during bootup, at LSI OpROM, you concurrently entered wrong or empty pass
phrase three times. Because of the “BIOS Continue on Error” feature, the booting process continues, but the
drives cannot be accessed.
To resolve this problem, do the following:
1
Reboot the system, and then enter the correct pass phrase.
2
From LSI WebBIOS, configure the new pass phrase or remove security.
SNMP Troubleshooting
SNMP Does Not Respond
To resolve this problem, do the following from the CIMC GUI.
Troubleshooting Guide for Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine
23
Overview
SNMP Troubleshooting
To Next Page
Loading...
Need help?
General
