Name: Cisco VG400
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

PurposeCommand or Action

Exits from the config-line mode and enters into the global

configuration mode.

Router(config-line)# exit

Step 6

Verifying the Host Name and Password

To verify that you configured the correct host name and password, perform the following steps:

SUMMARY STEPS

1. Enter the show config command:

2. Exit global configuration mode and attempt to re-enter it using the new enable password:

DETAILED STEPS

Step 1 Enter the show config command:

Example:

Router# show config

Using 2745 out of 262136 bytes

version XX.X

hostname 450

enable secret 5 $1$60L4$X2JYOwoDc0.kqa1loO/w8/

Check the host name and encrypted password displayed near the top of the command output.

Step 2 Exit global configuration mode and attempt to re-enter it using the new enable password:

Example:

Router# exit

Router con0 is now available

Press RETURN

to get started.

Router> enable

Password: guessme

Router#

If you face any issues, check whether:

• Caps Lock is off.

Cisco VG400 Voice Gateway Software Configuration Guide

Configuring with the Command-Line Interface

Verifying the Host Name and Password

Cisco VG400 User Manual

Other manuals for Cisco VG400