• You entered the correct password. Passwords are case sensitive.
Configuring a Gigabit Ethernet Interfaces
To configure a Gigabit Ethernet interface, use the configuration software provided with your Cisco VG400
Voice Gateway or network module, if any. Otherwise, for high power and flexibility, use the configuration
mode (manual configuration).
Before you begin, disconnect all the WAN cables from Cisco VG400 to prevent it from running the AutoInstall
process. Cisco VG400 attempts to run AutoInstall whenever you power the Voice Gateway on and there is a
WAN connection on both ends. Cisco VG400 does not have a valid configuration file stored in NVRAM (for
instance, when you add a new interface). It can take several minutes for Cisco VG400 to determine that
AutoInstall is not connected to a remote TCP/IP host.
Note
This section describes a basic configuration, including enabling the interface and specifying IP routing.
Depending on your requirements and the protocols that you plan to route, you might have to enter other
configuration commands.
Before you begin configuring the interfaces, perform the following tasks:
• Connect a console to Cisco VG400.
• Power on Cisco VG400.
SUMMARY STEPS
1. Router> enable
2. Router# configure terminal
3. Router# ip routing
4. Router(config)# interface gigabitEthernet 0/0/0
5. Router(config-if)# ip address 172.16.74.3 255.255.255.0
6. Router(config-if)# exit
7. Router(config-if)# Ctrl-z
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.Router> enable
Step 1
Example:
• Enter your password, if prompted.
Password: password
Example:
Router#
Cisco VG400 Voice Gateway Software Configuration Guide
8
Configuring with the Command-Line Interface
Configuring a Gigabit Ethernet Interfaces
To Next Page
Loading...
Need help?
General
