Cisco WAP131 Quick Start Guide 3
POWER—The POWER button is used to turn the power on and off. It is not
applicable when using PoE.
12V DC—The 12V DC jack is used to connect the supplied power adapter
to the Cisco WAP131 if you are not using PoE.
Kensington Lock Slot—The Kensington lock slot is used to attach a cable
and lock to the Cisco WAP131.
Default Settings
If you are using a Cisco RV Series router, the default range for the DHCP
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
Mounting the Cisco WAP131
You can place the Cisco WAP131 horizontally on a surface so that it sits on
its four rubber feet, or place it vertically on a desktop by using the stand on
its left side.
To place the Cisco WAP131 vertically on a desktop, follow these steps:
STEP 1 Locate the left side panel of the Cisco WAP131, and rotate the stand
90 degrees clockwise or anticlockwise.
STEP 2 Place the stand upward so that the Cisco WAP131 stands on a flat
desktop.
Parameter Default Value
Username cisco
Password cisco
LAN IP Address DHCP address assigned by server
Fallback LAN IP 192.168.1.245
Subnetwork Mask 255.255.255.0
To Next Page
Loading...
Need help?
General
