CKD FLUEREX PF Series User Manual

Flow sensor for compressed air (FLUEREX)
Medium ow rate
PF500F to PF4000F Series
● Flow rate range: 25 to 500, 50 to 1000,
100 to 2000, 200 to 4000 L/min(normal)
*1 :

If the compressed air contains foreign substances, water or oil, the ow rate cannot be detected and this causes "sensor error".
Install a lter, refrigeration air dryer, and oil mist lter on the upstream side of the ow rate sensor.
*2 :
When the ow rate is below the min. ow rate range, the display becomes 0. The display value out of the ow rate range is outside the guaranteed precision.
*3 : Note that the switch output is not available if option "A1" (4 to 20 mADC) or "A6" (integrated pulse) is selected.
*4 : Refer to descriptions of integrated pulse output on page 1383 for details of pulse output.
*5 : Note that the integrating ow value is reset when the power supply is turned OFF.
Specications
Descriptions
PF500F-
10
PF500F-
15
PF1000F-
10
PF1000F-
15
PF2000F-
15
PF2000F-
20
PF4000F-
20
PF4000F-
25
Specs
Flow rate range L/min(normal) 25 to 500 50 to 1000 100 to 2000 200 to 4000
Port size Rc3/8 Rc1/2 Rc3/8 Rc1/2 Rc1/2 Rc3/4 Rc3/4 Rc1
Working conditions
Applicable uid Compressed air, nitrogen
Air quality JIS B8392-1: 2012 (ISO 8573-1: 2010) [1:1:1 - 1:6:1] (*1)
Max. working pressure MPa 1.0 (≈150 psi, 10 bar)
Min. working pressure MPa 0.1 (≈15 psi, 1 bar)
Proof pressure MPa 1.5 (≈220 psi, 15 bar)
Ambient temperature °C 0 (32°F) to 50 (122°F)
Ambient humidity 85% RH or less
Fluid temperature °C 0 (32°F) to 40 (104°F)
Accuracy
Linearity ±1.5% FS (0.7 MPa (≈100 psi, 7 bar), 20°C (68°F))
Pressure characteristics ±1.5% F.S. (0.1 (≈15 psi, 1 bar) to 1.0 MPa (≈150 psi, 10 bar), 0.7 MPa (≈100 psi, 7 bar) reference)
Temperature characteristics ±2.0% F.S. (0 (32°F) to 40°C (104°F), 20°C (68°F) reference)
Pressure loss MPa 0.005 (≈0.73 psi, 0.05 bar) or less (max. ow rate, 0.7 MPa (≈100 psi, 7 bar))
Response time sec 2.5
Display 5-digit LED display Display unit: ℓ/min (normal)
Min. displayed ow rate (*2) 10 20 30 50
Display resolution 1 10
Integrating ow Max. 9 digits (however, H and L are split displayed).
Output
Analog output Standard: 0 to 5 VDC Option: 4 to 20 mADC, 1 to 5 V, 0 to 10 V
Switch output (*3) 1 piece (transistor open collector) Green LED turns ON when switch is ON
Pulse output (option) (*4) 10 L(normal)/pulse
Power supply voltage V 24 DC (8 W or less)
Cable Included (with 3 m connector/0.5 mm
2
conductor)
Set value hold function (*5) Semi-permanent due to EEPROM
Mounting
Mounting orientation Unrestricted in vertical/horizontal direction
Straight piping section Not required
Degree of protection IP64 or equivalent
Weight kg 0.85 1.4
Bracket weight g 60 g (including screws) 84 g (including screws)
F.R.L
F (Filtr)
R (Reg)
L (Lub)
PresSW
Shutoff
SlowStart
FlmResistFR
Oil-ProhR
MedPresFR
No Cu/
PTFE FRL
Outdrs FR
F.R.L
(Related)
CompFRL
LgFRL
PrecsR
VacF/R
Clean FR
ElecPneuR
AirBoost
SpdContr
Silncr
CheckV/
other
Jnt/tube
AirUnt
PrecsCompn
Mech/
ElecPresSw
ContactSW
AirSens
PresSW
Cool
AirFloSens/
Contr
WaterRtSens
TotAirSys
(Total Air)
TotAirSys
(Gamma)
RefrDry
DesicDry
HiPolymDry
MainFiltr
Dischrg
etc
Ending
1372
Discontinue

CKD FLUEREX PF Series Specifications

General

Brand	CKD
Model	FLUEREX PF Series
Category	Accessories
Language	English