CKD PPX Series User Manual

20
When designing and manufacturing a device using CKD products, the manufacturer is obligated to check
that device safety mechanical mechanism, pneumatic control circuit, or water control circuit and the
system operated by electrical control that controls the devices is secured.
It is important to select, use, handle, and maintain the product appropriately to ensure that the CKD
product is used safely.
Observe warnings and precautions to ensure device safety.
Check that device safety is ensured, and manufacture a safe device.
Always read this section before starting use.
Safety precautions
WARNING
1
This product is designed and manufactured as a general industrial machine part. It must be
handled by an operator having sufcient knowledge and experience in handling.
2
Use this product in accordance with specications.
Contact CKD when using the product outside the unique specications range, when using it outdoors, and when using
it under the conditions and environment below. Do not attempt to modify or additionally machine the product.
Use for special applications requiring safety including nuclear energy, railroad, aviation, ship, vehicle, medical equipment, equipment, or applications
coming into contact with beverage or food, amusement equipment, emergency shutoff circuits, press machine, brake circuits, or for safeguard.
Use for applications where life or assets could be adversely affected, and special safety measures are required.
4
Do not handle, pipe, or remove devices before conrming safety.
Inspect and service the machine and devices after conrming safety of the entire system related to this product.
Note that there may be hot or charged sections even after operation is stopped.
When inspecting or servicing the device, turn off the energy source (air supply or water supply), and turn off power
to the facility. Discharge any compressed air from the system, and pay enough attention to possible water leakage
and leakage of electricity.
When starting or restarting a machine or device that incorporates pneumatic components, make sure that the
system safety, such as pop-out prevention measures, is secured.
5
Observe warnings and cautions on the pages below to prevent accidents.
DANGER:
When a dangerous situation may occur if handling is mistaken leading to fatal or
serious injuries, or when there is a high degree of emergency to a warning.
WARNING:
When a dangerous situation may occur if handling is mistaken leading to fatal or
serious injuries.
CAUTION:
When a dangerous situation may occur if handling is mistaken leading to minor
injuries or physical damage.
Note that some items described as "CAUTION" may lead to serious results depending on the situa-
tion.In any case, important information that must be observed is explained.
3
Observe corporate standards and regulations, etc., related to the safety of device design and
control, etc.
ISO4414, JIS B 8370 (pneumatic system rules)
JFPS2008 (principles for pneumatic cylinder use and selections)
Such as High Pressure Gas Maintenance Law and Occupational Safety and Sanitation Laws, other safety rule and corporate standards and regulations
The safety cautions are ranked as "DANGER", "WARNING" and "CAUTION" in this section.
Disclaimer
1
Warranty period
"Warranty Period" is one (1) year from the rst delivery to the customer.
2
Scope of warranty
In case any defect attributable to CKD is found during the term of warranty, CKD shall, at its own discretion repair the
defect or replace the relevant product in whole or in part, according to its judgement.
Note that the following faults are excluded from the warranty term:
(1)
Product abuse/misuse contrary to conditions/environment recommended in its catalogs/specications
(2)
Failure caused by other than the delivered product
(3)
Use other than original design purposes
(4)
Third-party repair/modication
(5)
Faults caused by reason that is unforeseble with technology put into practical use at the time of delivery
(6)
Failure attributable to force majeure
The warranty mentioned here covers the discrete delivered product. Only the scope of warranty shall not cover losses
induced by the failure of the delivered product.
3
Compatibility conrmation
In no event shall CKD be liable for merchantability or tness for a particular purpose, notwithstanding any disclosure
to CKD of the use to which the product is to be put.

CKD PPX Series Specifications

General

Brand	CKD
Model	PPX Series
Category	Accessories
Language	English