Water droplets may form on Let it dry for about 1 hour with the power on
the internal lens when the
car is parked
in
a humid
place
Power does not
turn on
(No sound is
produced)
No sound output
when operating
the unit with
amplifiers or
power antenna
attached
Nothing happens
when buttons are
pressed
Sound is bad
directly after
power is turned
on
Incorrect wiring
Power antenna lead is
shorted to ground or
excessive current is required
for remote-on the amplifiers
or power antenna
The microprocessor has
malfunctioned due to noise,
etc
Playback head is dirty
B NR button [I] is not
pressed
Another CD is already
loaded
CD is dirty
CD is heavily scratched or
warped
Replace with a fuse of the same amperage If the
fuse blows again, consult your store of purchase
Consult your store of purchase
1 Turn the unit off
2 Remove all wires attached to the power antenna
lead Check each wire for a possible short to
ground using an ohm meter
3 Turn the unit back on
4 Reconnect each amplifier remote wire to the
power antenna lead one by one If the amplifiers
turn off before all wires are attached, use an
external relay to provide remote-on voltage
(excessive current required)
Press the reset button with a thin rod
~~jl
-~~
Use a cleaning tape,
etc,
to clean the head
When listening to a tape recorded with Dolby NR,
press
B NR button
[ID
and select B NR
Eject the CD before loading the new one
Clean the CD with a soft cloth
Replace with a CD with no scratches or no warped
ADX5655z
23
To Next Page
Loading...
Need help?
General
