Clarion ARX7370R User Manual

Manual tuning of related regional
stations
1. This function works when AF is on and REG
is off.
Note:
* This function is effective when related regional sta-
tions are received.
‘2. Press one of the Preset buttons [12] to recall a
regional station.
-3. If the receiving condition of a recalled station
is bad, press the same Preset button [12]. The
unit switches to a related regional station.
TA (Traffic Announcement)
When the unit is in the TA standby mode, you
can listen to traffic announcements preferentially
when they start, irrespective of the function mode.
You can also tune in to TP (traffic programme)
stations automatically.
@To set the TA standby mode
If you press TA button [10] when only “TP” is lit in
the display, “TP” and “TA” light in the display and
the unit is set to the TA standby mode until traffic
announcements start.
When traffic announcements start, “TRA INFO”
appears in the display, and then PS (Programme
Service Name) appears.
«i we
CLIT
Trem
LI bs
=
TRA
If you press TA button [10] while traffic announce-
ments are being broadcast, they are cancelled
and the unit enters TA standby mode.
@Cancelling the TA standby mode
If you press TA button [10] when “TP” and “TA” are
lit in the display, “TA” in the display goes off and
the TA standby mode is cancelled.
@ Setting the auto tuning mode for TP stations
If you press TA button [10] when only “TP” is lit or
“TP” and “TA” are not lit in the display, “TA” lights
and the unit automatically tunes in to TP stations.
Note:
¢ The unit continues to tune in automatically if no
TP station is received. Press TA button [10] again
to stop auto tuning.
RDS Operations
Auto store function for TP stations
@Auto storing while “TA” is lit:
Only TP stations are auto stored.
* Refer to PS/AS function in radio mode.
PTY
This function enables you to listen to selected
programme type, irrespective of the function mode.
PTY broadcasts are not yet available in all coun-
tries.
In TA standby mode, TP stations have priority over
PTY broadcasting stations.
* Emergency messages interrupt all modes of op-
eration. They can only be received from RDS sta-
tions. “ALARM” appears in the display and mes-
sage can be heard.
Press AF button [8] to cancel the “ALARM” broad-
casts.
«i bad
OOOO «a
ey
PIL. vcr
Selecting PTY
1. When you press PTY button [9], “PTY” lights
and PTY appears in the display. The unit en-
ters PTY select mode.
If the control is idle for 7 seconds after the PTY
select mode has been entered, the display au-
tomatically returns to radio mode display and
the unit enters the PTY standby mode.
2. Select a PTY.
Press one of Preset buttons [12] to select the
desired PTY or select up or down to obtain a
desired PTY using a-selector [2].
ARX7370R/ARX7370RW 15

Clarion ARX7370R Specifications

General

Brand	Clarion
Model	ARX7370R
Category	Cassette Player
Language	English