41
MAX685BT
English
Owner’s manual
6. SOURCE OPERATIONS
(ACCESSORIES)
XM Satellite Radio Operations
This function is available when an XM tuner is connected.
This unit can control the following satellite radio receiver:
• XM Mini-Tuner
Note:
• Be sure to turn off the ACC power before connecting/disconnecting the XM tuner.
Selecting the XM mode
1. Press the [SRC] button, and touch the [XM]
key.
The system changes to the XM mode.
Note:
• If the [XM] key is not displayed or the message
“CHECK XM TUNER” is displayed, check the
connection with the XM Satellite Radio Receiver.
• The audio output is muted and other button
operations are not accepted during channel
selection.
● Information displayed during reception
The following information is displayed when the
satellite radio cannot be received normally.
• When a channel is being tuned in (no signal is
yet received): “LOADING”
• A channel without a broadcast has been
selected: “CH UNAVAILABLE”
• A channel not covered by your contract: “CH
UNAUTHORIZED”
• When a channel is out of air time: “OFF AIR”
• When no signal is received: “NO SIGNAL”
• When the XM antenna is not connected
correctly : “CHECK ANTENNA”
Selecting a band
1. Touch the [Band] key to select a band.
This changes the reception band as follows:
XM1 ➜ XM2 ➜ XM3 ➜ XM1 ...
Confirming your Radio ID
1. Touch the [Options] key to display the
Options screen.
2. Touch the [Direct] key to display the Key Pad
screen.
3. Touch the [0] key, then touch the [ENT] key.
Receiving the Channel “0” will display your
Radio ID (8-digits number).
Switching the operation mode
Usually, the system will operate in the Channel
selection mode. You can switch this to the
Category selection mode by the following
operation.
1. Touch the [CAT] key to switch to the Category
selection mode.
If you do not perform operation for 15
seconds, the system will automatically return
to the Channel selection mode.
• Touch the [Back] key to switch to the
Channel selection mode within 15 seconds.
To Next Page
Loading...
Need help?
General
