x : Tap to increase the speed of the simulation to 4, 8 or 16 times faster. Tap again to
return to normal speed.
5. Tap
to stop the simulation.
3.7 Off-road navigation
When first started, NX405 calculates routes using the road network of the maps provided with the
product. If you want to disregard roads during navigation, you can switch to off-road mode, for example
when driving in a desert.
3.7.1 Switching to off-road navigation
To switch to off-road navigation, perform the following steps:
1. On the Navigation view, tap
, , and .
2. Tap
and select .
Most of the procedures described for on-road navigation also apply to off-road navigation. However, there
are some that are not available in this navigation mode. For example:
x You cannot open the itinerary as you have no maneuvers just route points and straight lines
between them.
x There are no route alternatives and route planning method.
x Vehicle settings are disabled.
3.7.2 Selecting the destination in off-road mode
Selecting a destination (waypoint or final destination) is the same as described in the previous sections.
The only difference is that route points are linked to form a route with straight lines regardless of the road
network and traffic regulations.
64 Clarion NX405 English
To Next Page
Loading...
Need help?
General
