EasyManuals Logo
Home>Clarion>Car Receiver>NX503E

Clarion NX503E Installation Manual

Clarion NX503E
7 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
52 NX503E/FX503E
English
Connection Notes
WARNING
• Loom all cables according to the
instruction manual, so as not to
hinder operation.
• Wire the connecting cords/cables
away from high temperature areas.
If the coatings of the cables melt,
it could cause an accident/fire by a
short circuit. Take care when wiring
in the engine compartment.
• When wiring the connecting cables
in a vehicle with an airbag system,
never feed the cables through
a place where it may affect the
operation of the airbag.
An airbag not operating correctly in
an emergency may cause increased
injury.
CAUTION
• Verify wires with a digital multi-meter
prior to making any connections.
Many new vehicles use multiplexed
and/or low voltage circuits that can
be damaged if a test light or logic
probe is used.
• Connect cables appropriately. If a
wrong connection is made, this may
cause a fire or accident.
• When passing cables through
the body of the vehicle, use non-
conductive grommets.
If the coatings of the cables are
worn out by rubbing, this may cause
an accident, fire or a short circuit.
• After wiring cables, fix them with
insulation tape.
• Be sure to switch off the vehicle
when connecting or disconnecting
cables to/from the unit, otherwise
an electric shock, injury or accident
may occur.
2. PACKAGE CONTENTS
Main unit
Quick Start Guide & Installation
Manual
CD-ROM
•Owner's manual
•Owner's manual - Navigation (NX503E
only)
Power supply cable
RCA pin cable (6ch)
RCA pin cable (Rear AUX-IN/Rear
Video Out)
Bag for accessories
•Flat head screw (M5 × 8 mm)
............................................................8
•Hexagonal bolt (M5 × 8 mm)
............................................................8
•Electro tap...........................................1
•Rubber cap (for RCA pin cable)
..........................................................10
•Cable holder (NX503E only) ................3
•Double-sided tape for fastening GPS
antenna (NX503E only) .......................1
•Cable tie ..............................................1
Warranty card
GPS antenna (NX503E only)
USB Cable
Notice
• The provided disc (CD-ROM manual)
cannot be played back on this unit.
3. GENERAL CAUTIONS
Do not open the case. There are no user-
serviceable parts inside. If you drop
anything into the unit during installation,
consult your dealer or an authorized
Clarion service center.
4. CAUTIONS ON
INSTALLATION
Prepare all articles necessary for
installing the main unit before starting.
Install the unit within 30° of the horizontal
plane. (Figure 1)
Max. 30°
Figure 1
If you have to do any modification on the
car body, such as drilling holes, consult
your car dealer beforehand.
Use the included screws for installation.
Using other screws can cause damage.
(Figure 2)
Figure 2
Chassis Chassis
Damage
Max. 3 mm (M4 screw)/
Max. 8 mm (M5 screw)

Other manuals for Clarion NX503E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clarion NX503E and is the answer not in the manual?

Clarion NX503E Specifications

General IconGeneral
MP3 playback-
DVD Audio playbackYes
Aspect ratio16:9
Display typeTFT
Display diagonal6.2 \
Display resolution800 x 480 pixels
Output power18 W
Product colorBlack
Frequency range20 - 20000 Hz
Disc types supportedDVD+R, DVD+RW, DVD-R, DVD-RW
Signal-to-Noise Ratio (SNR)93 dB
AM band range530 - 1710 kHz
FM band range87.9 - 107.9 MHz
Supported radio bandsAM, FM
BluetoothNo
Line outputs (RCA)2
Weight and Dimensions IconWeight and Dimensions
Dimensions (WxDxH)178 x 157 x 100 mm

Related product manuals