2
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
INTRODUCTION
Thank you for purchasing this CLARKE ARC/TIG Welder.
Before attempting to operate the machine, it is essential that you read this
manual thoroughly and carefully follow all instructions given. In doing so you
will ensure the safety of yourself and that of others around you, and you can
also look forward to the welder giving you long and satisfactory service.
The ARC/TIG welder, as its name suggests, is designed to be used for both
Metal ARC/ TIG welding. To accomplish this, two sets of welding leads are
required, one for each method employed.
TIG welding leads are not supplied with the machine. These are however
readily available from your CLARKE dealer. For the AT101 and AT132 (Part
number 6012232) for the AT161 (part number 6012233)
GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period of
12 months from the date of purchase. Please keep your receipt as proof of
purchase.
This guarantee is invalid if the product is found to have been abused or
tampered with in any way, or not used for the purpose for which it was
intended.
Faulty goods should be returned to their place of purchase, no product can
be returned to us without prior permission.
This guarantee does not effect your statutory rights.
UNPACKING
Any damage or deficiency should be reported to your CLARKE dealer
immediately. you should find inside the following:
• 1 x ARC / TIG Inverter Welder • 1 x Wire Brush / Hammer
• 1 x Electrode Clamp & Cable • 1 x Carrying Strap (fitted)
• 1 x Earth Clamp & Cable • 1 x Instruction Manual
To Next Page
Loading...
Need help?
General
