Disassembly
2 - 6 Removing and Installing the Hard Disk Drive
2.Disassembly
Removing and Installing the Hard Disk Drive
Hdd Removal Procedure
The hard disk drive can be taken out to accommodate other 2.5" serial (SATA) hard disk drives with a height of 9.5mm
(h). Follow your operating system’s installation instructions, and install all necessary drivers and utilities (as outlined in
Chapter 4 of the User’s Manual) when setting up a new hard disk.
Hard Disk Upgrade Process
Figure 2
HDD Assembly
Removal
a. Remove the screws.
b. Remove the hard disk
bay cover.
HDD System Warning
New HDD’s are blank.
Before you begin make
sure:
You have backed up
any data you want to
keep from your old
HDD.
You have all the CD-
ROMs and FDDs re-
quired to install your op-
erating system and
programs.
If you have access to
the internet, download
the latest application
and hardware driver up-
dates for the operating
system you plan to in-
stall. Copy these to a re-
movable medium.
1. Turn off the computer, and remove the battery (page 2 - 5).
2. Remove the screws - .
3. Lift the hard disk bay cover up from point .
4. Remove the hard disk bay cover from the computer.
2
1
3
b.a.
4
4. Hard Disk Bay Cover
•2 Screws
To Next Page
Loading...
Need help?
General
