Engraving material list
Problem summary
The data listed in this list are all reference values. Because each material has different characteristics and differences,
there is a certain error. In general, the use of relatively high power (1600MW is relatively high power compared to
500MW), the engraving depth is relatively deep, but due to the focal length, it will be less detailed than the low
power. Small power engraving is shallow but very fine. When engraving, you can adjust the power, engraving speed,
and moving speed for better results. In addition, when the speed is slow, it can be cut, but if the edge is not fine and
the degree of burning is obvious, you can try to adjust the speed and repeat the engraving several times to achieve
better results. If it is cutting, please adjust the speed as appropriate to achieve the cutting effect. If it is engraving,
please adjust the parameters such as power and speed according to the depth of engraving.
Q : What materials can the laser engraving machine engrave or cut?
Please refer to the "Carving Material List"
Q : What is the difference in power size?
The higher the power, the greater the luminous energy of the laser head, the higher the temperature of the material hit,
the harder the material of the material that can be engraved, and even the full cutting can achieve the cutting effect.
However, the pattern carved out by high power is not small enough for fine power. If it is cutting, it is recommended
to choose high power; if it is required to engrave shallower, more delicate, it is recommended to choose low power.
Q: How long does the laser head last?
In theory it is 8,000 hours. (The life of the laser varies depending on the environment and usage of each user. This
issue is for reference only)
Q: How high can the engraving precision be achieved?
The power is different and the precision of the engraving is different. In general, the larger the power, the larger the
laser spot (the spot on the material), so it cannot be engraved fine. In general, low power (300MW 500MW) engrav-
ing accuracy can be achieved.
Q : Which formats or formats are supported?
Support all formats of images, support GCODE, NC files
Q: Is the laser head focal length adjustable?
Adjustable. Click the “Weak Light On” button on the touch screen interface, then rotate the knob under the laser head
to make the spot on the material as small as possible. The smaller the spot, the greater the energy.
Q : Whether to support the grayscale engraving function
Supports the grayscale engraving function, which can engrave pictures and photos of different shades of color by
controlling the intensity of the laser according to the color depth of the image.
Q : Is there a positioning function? How to locate?
When using online engraving, you can turn on the low light, move the laser head to the place to be engraved, click
the “Position” button to set the point to zero.
When using offline engraving, turn on the low light, move the laser head to the place to be engraved, click the “Posi-
tion” button to set the point to zero, select the file to be engraved, and confirm the range of the photo to be engraved
by walking the border. For accurate positioning.
To Next Page
Loading...
Need help?
General
