Push and release button again.
MAIN CHANNEL will flash and only the
MEM
icon will remain flashing.
Push and release button until
MEM
icon and
a memory location flashes.
Select memory location you wish to change by
pushing and releasing buttons (Use
MEM 6 for this example).
3
5
Advanced Features
23
Note
Once you enter memory
mode you can talk and listen
to any channel you select
after programming is
complete. See Using Memory
Locations section on
page 26.
continued
Advanced Features
22
Programming Memory Locations
Your MicroTalk 3 has 10 memory (0-9) locations
for storing your most frequently used channels.
Rotate ON - OFF Volume Control clockwise.
An audible “tone” will indicate the unit is on
and then the LCD will go through a 3 second
self-test and then go to operational mode.
Programming
Memory
Locations
2
1
4
Channel
Function
Function
Channel
Select desired main channel you wish to store
(1-14) by pushing and releasing
buttons.(Use CHANNEL 12 for this example.)
FRS300.MANUAL.qx 10/2/98 12:39 PM Page 28
To Next Page
Loading...
Need help?
General
