23" CABINET ASSEMBLY NO. 507493
FOR MODEL NO. 113.198210
A Right Side Panel ............................ 1
B Left Side Panel ........................... 1
C Lower' Shelf ............................... 1
D Skirt ....................................... 2
E Shelf Stiffener . ........................... 1
F Corner Bracket ............................ 2
G Spacer ................................... 2
H Door'......................................1
t Caster, Stationary ......................... 2
D
A
H
F i F
%
G
................ i i ii i:llllllllll i i lllllll i,iii, lUlHI
2. After layout of stand parts, take the lower shelf
and turn upside down on floor. Small front flange
should be pointing upward.
3o Locate the shelf stiffener, two (2) stationary
casters and eight (8) 1/4-20 x 7/!6 slotted truss
head bolts, Iockwashers and hex nuts.
4 Line up the holes in the lower shelf with the holes
in the shelf stiffener and caster Assemble truss
head bolts, Iockwashers and hex nuts as illus-
trated. Assemble both casters to shell
5 Locate the two (2) corner brackets, four (4) 1/4-
20 x 1/2 truss head bolts, Iockwashers and nuts
Attach the corner brackets to the front flange in
holes as illustrated. Attach both corner brackets
SHELF
STIFFENER
LOWER
SHELF
I_e,".;10x ?;1_i'
/lr'.i r,r_ /
6 Locatethe two (2) side panelsand six (6) 1/4-20 x
1/2 truss head bolts, Iockwashers and hex nuts
Place the right side panel on its back side as
illustrated_ Stand up the lower shelf on the rear
flange and line up the holes on the corner
bracket and shelf stiffener with the holes in the
side panel. Mount the bolts in the three holes and
tighten hex nuts with a 7/16" wrench or socket
Repeat procedure for left side panel
CORNER BRACKET
SHELF
SHELF STIFFENER
REAR FLANGE
RIGHT SIDE
PANEL
12
To Next Page
Loading...
Need help?
General