ATTACHING TRiM CAPS & TRiM LEDGE
1. Locate the two (2) trim caps, the trim ledge, and
from loose parts bag 498 four (4) sheet metal
type "B" #10 x i and six (6) type BT screws 1/4 x
1/2o
2_ Place the trim ledge against the bottom of the
base using two (2) type"B" metal screws, secure
the trim ledge to the base from below using a
phillips screwdriver.
TRIM LEDGE
3, Then reach through the base and secure the trim
ledge with type "BT" screws using a phillips
screwdriver_
4, Position the trim caps in place and hold in place
with a type "B" metal screw from the bottom side.
5. Then reach through the base and secure the trim
cap with two (2) type "BT" screws using a phillips
screwdriver. Repeat procedure for other side,
16
To Next Page
Loading...
Need help?
General