9.CLAMPING FORCE NOT SUFFICIENTAT
MITERANGLESOTHERTHAN45°,
aoMiter Lock Handle requires Adjustment.
Refer to Adjusting Miter Lock Handle in Adjust-
ments to Compensate for Wear Section
10. CLAMPING FORCE NOT SUFFICIENT AT
BEVEL ANGLES OTHER THAN 45°.
a, Bevel Lock Handle Requires adjusting.
Refer to Adjusting Bevel Lock Handle in Adjust-
ments to Compensate for Wear Section,
11. DEPTH OF CUT VARIES FROM ONE END OF
WORK PIECE TO THE OTHER.
a, Table Top not parallel with Arm,
Refer-to attaching and leveling table mounting
support channels in Step Two of the Alignment
Procedure Section.
12, BLADE TENDS TO ADVANCE THROUGH
LUMBER TOO FAST°
a, Dull Blade.
Replace or sharpen blade.
b, Not advancing Saw Blade properly.
Draw Saw Blade across lumber with a slow
and steady pull
46
To Next Page
Loading...
Need help?
General