k¸ :._
SHARPENING
1. Adjust table, to proper angular position for: intended
operation. Cock securely.
2_ When_sharpening short: cutting tools such as wood
chisels; it wii[ be neceSsaW 1_oclamp a piece of wood to:
the table.
3. Sand a notch on the back of the Wood so that the top
corner is close to the belt_
4. Move the cutting tool across the belt, pushing on it
gently sotbet it does not burn.
5. Frequently quench the cutting tool in water to keep it
cool.
I //
///
N_ON
BACKOF WOOD
POL ISHING
1: RemoVe platen and adjust upper idler as shown or swing
it to the rear.
2. Push the workpiece against the belt,., move it gently so
that the bett does not come off the wheels.
3. If the workpiece is metal, frequently quench it in water
to keep it cool and prevent it from biJrning.
t
!
I
I
I
I
I
t
I
I !1 qllll , rill i
III IIII
MAINTENANCE
LUBRiCATiON
WARNING: REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE MAINTAINING OR LUBRICATING
YOUR SANDER/GR INDER.
Keep the Sander/Grinder and motor clean. Frequently blow
out:duSt and chips.
The upper and lower wheels run on ball bearings which are
permanently lubricated; They require no further
lubrication.
The idlers contain bronze bearings, Occasionally apply a
few drops of light machine oi!.
To Next Page
Loading...
Need help?
General