0105
115V
230V
①
②
③
• Please ensure the correct position for the power supply switch and mains before supply connection, in order to avoid damage to
the device.
• If the mains between 100V and 120V, please select the 115V for the power supply switch.
• If the mains between 200V and 240V, please select the 230V for the power supply switch (default is 230V).
A. Open the device’s cover.
D. Remove the foam from the inside
of the device.
E. Check whether the moving mechanisms
are moving smoothly.
F. Note: Please ensure that the voltage matches the power
switch, otherwise the power supply may be damaged or
burnt out.
B. Use the cutting plier to cut the cable
ties around the nozzle.
C. Use the cutting plier to cut of f the cable ties on the
X-axis and Y-axis belts, and remove the cut cable
ties and foam.
2. Instructions for Use
Notes
2.1 Unboxing instructions
To Next Page
Loading...
Need help?
General
