Cub Cadet Time Saver User Manual

18 se c t i O n 5 — ba g g e r as s e M b l y & in s t a l l a t i O n : tw i n up p e r ba g g e r cO M p O n e n t s
Open Hood by pushing in on the rear, right-side tab with 7.
your right hand, as seen in 1 of Fig. 5-11, and lifting the cover
with your left hand in the center rear of the bagger cover, 2.
Install both grass bags onto the bag support assembly 8.
by inserting the front edge in first (1), as seen in Fig. 5-12,
and setting the back edge down (2) until it fits into the
assembly.
Slide the hinge pin into the hole located on the mounting 6.
tab, as in Fig. 5-9. Use the cut-out window (See inset in Fig.
5-9) to line up the hinge pin on the other side and push pin
all the way in until it reaches the end-stop. At this point the
pin clips into place and is secured by a tab in the bagger
cover. See Fig. 5-10.
1
2
Figure 5-11
Figure 5-10
Figure 5-9
1
2
Figure 5-12

Cub Cadet Time Saver Specifications

General

Brand	Cub Cadet
Model	Time Saver
Category	Lawn Mower
Language	English