4
UNPACKING
Inspect the UPS upon receipt. The box of PR3000 should contain the following:
(1) UPS Unit; (1) User’s Manual; (2) Rack Mount Brackets; (2) Stands; (1)
PowerPanel Plus Software Disk; (1) PowerPanel Software Disk; (1) Telephone Cable;
(2) Serial Interface Cables (RS232); (1) Serial-to-USB cable
HOW TO DETERMINE THE POWER REQUIREMENTS OF YOUR
EQUIPMENT
1. Insure that the equipment plugged into the seven battery power-supplied outlets
does not exceed the UPS unit’s rated capacity (3000VA/2200W for PR3000). If
rated unit capacities are exceeded, an overload condition may occur and cause the
UPS unit to shut down or the circuit breaker to trip.
2. If the power requirements of your equipment are listed in units other than
Volt-Amps (VA), convert Watts (W) or Amps (A) into VA by doing the calculations
below. Note: The below equation only calculates the maximum amount of VA that
the equipment can use, not what is typically used by the equipment at any one
time. Users should expect usage requirements to be approximately 60% of the
maximum value.
INSTALLATION
BLOCK DIAGRAM
To Next Page
Loading...
Need help?
General
