42
Installing and Removing the Infant Carrier
Installing with Base Using Lap/Shoulder Belts
1. Ensure that Rigid LATCH is in the storage
position and, if equipped, unfold the Load
Leg from underneath the Base.
2. Position Base on a rear vehicle seat.
NOTE: If necessary, the Base may
be installed with the Load Leg folded
up underneath the Base. Consult the
vehicle owner's manual and the Load Leg
Warnings on pages 21-22 of this manual.
If ALL installation requirements for the
Load Leg cannot be met, you MUST
choose another seating position or install
the Infant Carrier without the Base.
3. Adjust the Leveling Foot to
achieve the correct range for
your child's weight as shown
on the Level Indicator.
!
WARNING! DEATH or SERIOUS INJURY can occur.
NEVER install this child restraint using a non-locking vehicle lap shoulder belt. A locking
clip must be used with a vehicle belt that DOES NOT LOCK. Call CYBEX Customer Care
at 1-877-242-5676 to obtain a locking clip.
Front of vehicle
qq
ww
ee
9 - 15.8 kg
(20 - 35 lbs)
1.8 - 9 kg
(4 - 20 lbs)
Recline Indicator
9 - 15.8 kg
(20 - 35 lbs)
1.8 - 9 kg
(4 - 20 lbs)
Recline Indicator
CY_171_8559_A0821
To Next Page
Loading...
Need help?
General
