[SELECT] button until watts disappears. Torque is now being displayed. To zero torque hold
down the [SELECT] button until the value reads zero. To exit torque mode press [SELECT] once.
If re-zeroing the torque does not recalibrate the unit, call Saris Cycling Group customer service
at 1-800-783-7257.
Speed seems incorrect
· Wheel size incorrect -refer to setup 1 and enter the correct size in setup mode.
Transmissio
n icon flashes rapidly
· Hub batteries need replacement - replace the hub batteries as shown in the maintenance
section of the User Manual.
Warranty
CycleOps PowerTap is warranted to the original retail purchaser to be free from defects in materi-
als and workmanship. Warranty coverage is valid to the original purchaser only and proof of pur-
chase will be required.
Electronics - 1 year
This warranty does not cover:
1. Normal wear and tear.
2. Any damage, failure or loss caused by accident, misuse, neglect, abuse,
improper assembly,
improper maintenance, or failure to follow instructions or warnings in Owner’s Manual.
3. Use of products in a manner or environment for which they were not designed.
Limitations
The foregoing warranties are in lieu of and exclude all other warranties not expressly set forth
herein, whether expressed or implied by operation of law or otherwise, including, but not limited
to, warranties of merchantability or fitness for a particular purpose. Saris Cycling Group shall in
no event be liable for incidental or consequential losses, damages or expenses in connection
42
To Next Page
Loading...
Need help?
General
