28D-Link DCS-700L User Manual
Section 7: Advanced Features
Advanced Features
Enabling Direct Connect
1
Press and hold the Direct Connect button on the back of the camera for
at least ve seconds. The Cloud LED will start blinking blue, indicating
the Direct Connect mode is enabled.
2
Connect your mobile device to the myBabyCam-xxxx Wi-Fi network. (XXXX
is a 4-digit code, the last 4 digits of your camera’s MAC address.) Use the
Wi-Fi password you created during the Setup Wizard installation process.
During the initial steps with the Setup Wizard, you congured the camera to connect to your home Wi-Fi network. If you want to take your camera
with you, it's not a problem with the DCS-700L.* You can connect directly to your camera, which means there is no need for an Internet connection
or a router. Follow the steps below to enable Direct Connect.
Note: Once you are connected to the camera, you will no longer have Internet
access.
*You have the option of using a portable USB battery pack (not included) that supplies 5V/2A of power when you take the camera with you. Plug
the USB battery pack into the Micro USB power port. The Power LED on the bottom of the camera will turn red when the camera is powered on.
Direct Connect