19D-Link DIR-605 User Manual
Section 3 - Conguration
Choose Dynamic IP Address to obtain IP Address
information automatically from your ISP. Select this option
if your ISP does not give you any IP numbers to use. This
option is commonly used for Cable modem services.
The Host Name is optional but may be required by some
ISPs. The default host name is the device name of the
Router and may be changed.
The default MAC Address is set to the WAN’s physical
interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address
unless required by your ISP.
The default MAC address is set to the WAN’s physical
interface MAC address on the Broadband Router. You
can use the “Clone MAC Address” button to copy the MAC
address of the Ethernet Card installed by your ISP and
replace the WAN MAC address with the MAC address
of the router. It is not recommended that you change the
default MAC address unless required by your ISP.
Enter the DNS (Domain Name Server) server IP address assigned by your ISP.
Dynamic IP
Address:
Host
Name:
MAC Address:
Internet Setup
Dynamic
Clone MAC
Address:
DNS
Addresses:
MTU:
Maximum Transmission Unit - You may need to change the MTU for optimal performance with your specic ISP.
Access
Point
Mode:
Checking this box disables NAT and turns the Router into
an Access Point only.
To manually set up the Internet connection, click the Manual Internet Connection Setup button on the Router’s
opening window.
To Next Page
Loading...
Need help?
General
