KEYBOARD “HOT KEY COMMANDS
To send “Hot Key” commands to the DKVM-2/4 unit, press the
SCROLL LOCK Key twice within 2 seconds.
You will be given a beep as confirmation. Now press a command key
to give a “Hot Key” command. The following commands are supported:
FIRST KEY SECOND KEY THIRD KEY COMMAND
SCROLL LOCK SCROLL LOCK 1 Switch to First PC
SCROLL LOCK
SCROLL LOCK
2 Switch to Second PC
SCROLL LOCK SCROLL LOCK 3 Switch to Third PC
SCROLL LOCK SCROLL LOCK 4 Switch to Fourth PC
SCROLL LOCK SCROLL LOCK ? Switch to Previous PC
SCROLL LOCK SCROLL LOCK ? Switch to Next PC
SCROLL LOCK SCROLL LOCK S Go to Auto Scan mode
In Auto-Scan mode, the DKVM-2/4 unit will switch to the next
computer every 10 seconds. This means that all computers will be
shown on the monitor in a row, starting with the first computer after the
last one has been shown.
In this mode, there is no mouse or keyboard control, which is needed
to prevent errors. Erratic input will result if a mouse move or keyboard
key press is given just as the unit switches to the next computer.
To exit Auto-Scan mode, press the SPACE BAR. The DKVM-2/4 will
stop at the last computer shown.
OPTIONAL CABLE
Model No. DKVM-CB 6 feet (180cm) 3-in-one Cable kit is available for
DKVM-2/4 KVM switch. Visit www.dlinkshop.com for details.
To Next Page
Loading...
Need help?
General
