Troubleshooting
D-Link DSL-2640B User Manual 116
Troubleshooting
This chapter provides solutions to problems that might occur during the installation and operation of the DSL-2640B. Read the following
descriptions if you are having problems. (The examples below are illustrated in Windows® XP. If you have a different operating system, the
screenshots on your computer will look similar to the following examples.)
1. How do I configure my DSL-2640B Router without the CD-ROM?
Connect your PC to the Router using an Ethernet cable.
Open a web browser and enter the address http://192.168.1.1 .
The default username is ‘admin’ and the default password is ‘tot’.
If you have changed the password and cannot remember it, you will need to reset the Router to the factory default setting (see question 2),
which will set the password back to ‘tot’.
Note:
Please
refer
to
next
section
Network
Basics
to
check
your
PC’s
IP
configuration
if
you
can’t
see
the
login
window.
2. How do I reset my Router to the factory default settings?
Ensure the Router is powered on.
Press and hold the reset button on the back of the device for about one second.
This process would take about 1~2 minutes to complete.
Note:
Resetting
the
Router
to
the
factory
default
settings
will
erase
the
current
configuration
settings.
To
reconfigure
your
settings,
log
in to
the
Router
as
outlined
in
question
1.
3. What can I do if my Router is not working correctly?
There are a few quick steps you can take to try and resolve any issues:
Follow the directions in question 2 to reset the Router.
Check that all the cables are firmly connected at both ends.
Check the LEDs on the front of the Router. The Power indicator should be on, and the DSL and LAN
indicators should be on as well.
Please ensure that the settings in the Web-based configuration manager, e.g. ISP username and password etc., are the same as the settings
provided by your ISP.
4. Why can’t I get an Internet connection?
For ADSL subscribers, please contact your ISP to make sure the ADSL service has been enabled, and your ISP username and password are correct.
To Next Page
Loading...
Need help?
Power
Data Transfer Rates
