D-Link DSL-2640U User Manual

DSL-2640U Wireless ADSL2+ Router with Ethernet WAN Support
User Manual
Configuring via Web-based Interface
'
In order to connect your device to an ADSL line, on the Device mode page, from the
Connection method list, select the ADSL value. In this mode you can configure a WAN
connection, set your own settings for the wireless network, configure LAN ports to connect an STB
or VoIP phone, and set your own password for access to the web-based interface of the device.
Figure 22. Selecting an operation mode. The ADSL connection method.
In order to connect your device to an Ethernet line, on the Device mode page, from the
Connection method list, select the Ethernet (LAN) value. In this mode you can configure a
LAN port as a WAN port, configure a WAN connection, set your own settings for the wireless
network, configure LAN ports to connect an STB or VoIP phone, and set your own password for
access to the web-based interface of the device.
Figure 23. Selecting an operation mode. The Ethernet (LAN) connection method.
When the operation mode is selected, click the NEXT button.
Page 34 of 174

D-Link DSL-2640U Specifications

Power

input voltage	100V-240V
input current	0.6A
input frequency	50 Hz - 60 Hz
output voltage	12V
output current	1A

Data Transfer Rates

G.dmt full rate downstream	up to 8 Mbps
G.dmt full rate upstream	up to 1 Mbps
G.lite ADSL downstream	up to 1.5 Mbps
G.lite ADSL upstream	up to 512 Kbps
G.dmt.bis full rate downstream	up to 12 Mbps
G.dmt.bis full rate upstream	up to 1 Mbps
ADSL2+ full rate downstream	up to 24 Mbps
ADSL2+ full rate upstream	up to 1 Mbps

Wireless Transfer Rates

IEEE 802.11b transfer rates	11, 5.5, 2, and 1 Mbps
IEEE 802.11g transfer rates	6, 9, 12, 18, 24, 36, 48, 54 Mbps

Media Interface

ADSL interface connector	RJ-11 connector for connection to 24/26 AWG twisted pair telephone line
LAN interface ports	four RJ-45 ports for 10/100BASE-T Ethernet connection