DSL-522T ADSL Router User Guide
PPPoE/PPPoA
Follow the instructions below to configure the Router to use a PPPoE or PPPoA for the Internet connection.
Make sure you have all the necessary information before you configure the WAN connection.
WAN Settings window – PPPoE/PPPoA
To set up a PPPoE or PPPoA connection:
1. If not already selected, choose the PPPoE/PPPoA option from the WAN Settings pull-down menu.
PPPoE/PPPoA is selected by default if you are configuring the Router for the first time.
2. Under the ATM VC Settings at the top of the window should not be changed unless you have been
instructed to change them. However, if you are instructed to change the VPI or VCI values, type in the
values assigned for your account. Leave the PVC and Virtual Circuit setting at the default (Pcv0 and
Enabled) values for now. This can be used later if you are configuring multiple virtual circuits for your
ADSL service. For more information, see the section on ATM VC Settings later in this manual.
26
To Next Page
Loading...
Need help?
General
