D-Link GO-SW-5E User Manual

9
CONNECTING THE SWITCH
PC to GO-SW-5E
A computer can be connected to the GO-SW-5E via a two-pair Category 3,
4, 5 UTP/STP Straight-Through or Crossover cable. A computer equipped
with a RJ-45 10/100Mbps port can be connected to any of the five GO-
SW-5E ports.
The LED indicators for the PC connection depend on the capability of the
computer’s Ethernet card. If the LED indicators are not lit after making a
proper connection, check the computer’s Ethernet card, the cable, and the
GO-SW-5E’s conditions and connections.
Hub to GO-SW-5E
A hub (10 or 100BASE-TX) can be connected to the GO-SW-5E via a
two-pair Category 3, 4, or 5 UTP/STP Straight-Through or Crossover
cable. For 100Mbps operation a Category 5 cable must be used. The
connection is accomplished from any port of the hub to any port of the
GO-SW-5E.
GO-SW-5E to other devices
The GO-SW-5E can be connected to another switch or other devices
(routers, bridges, etc.) via a two-pair Category 3, 4, 5 UTP/STP Straight-
Through or Crossover cable. A Category 5 cable must be used for
100Mbps operation. The connection can be accomplished from any (MDI-
X) port on the GO-SW-5E to any of the 10Mbps or 100Mbps (MDI-X)
ports on another switch or other devices.

D-Link GO-SW-5E Specifications

General

Switch type	Unmanaged
Switch layer	-
Power connector	DC-in jack
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports type	Fast Ethernet (10/100)
Basic switching RJ-45 Ethernet ports quantity	5
10G support	No
Full duplex	Yes
Networking standards	IEEE 802.3, IEEE 802.3az, IEEE 802.3x
MAC address table	2000 entries
Power consumption (typical)	0.9 W
Number of power supply units	1
Product color	White
LED indicators	Activity, Link
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	47.85 mm
Width	87 mm
Height	21.7 mm