3. Next attached the hose exit ring (3) to the other end of the hose as
follows:
e. Hook the at
part of the hose
connector (2)
into the slot on
the rear of the
unit as shown
left.
f. Bring the hose
connector (2) towards
the back of the unit
until the notches in the
connector line up with
the tongues on the
rear of the unit. Finally
slide the connector
down in the direction
of the arrow shown
left.
4. Place the exit end of the hose through a suitable outlet such as an
open window, door, etc.
NB the unit must be positioned a minimum of 1 metre from any wall or
obstruction on all sides.
Before use, check the exible vent hose is properly tted.
Ensure the unit is on a level dry surface and the mains supply meets the
requirements of the unit.
Do not share sockets with other appliances via a mains adaptor or other
means.
Using the Air Conditioning Unit
Cooling Operation
1. Turn the unit on using the ON/OFF button.
2. Press the Mode Button until the Cool indicator illuminates.
3. Press the Temperature + or Temperature – Button to select a desired
room temperature (16˚C - 31˚C).
4. Press the Fan Speed Selection Button to choose the required air ow
speed.
NOTE: To create a circulatory eect, the cooled air leaves the unit at
an angle and slightly to one side. This is to make space cooling more
ecient and is normal.
To Next Page
Loading...
Need help?
General
