32
2-2) Audio Azimuth Adjustment
• Adjustment Procedure
1. Preparation
1) Set the VCR to the PLAY mode
2) Set the Scope connector to the P602.
3) Adjust first screw on the plate under the AC head to maximize scope's signal width.
2. Adjustment Inspection standard : [Maximum Point]
Item Mode Adjustment parts Check point Test equipments Test tape Input signal
Audio Azimuth
PLAY AC HEAD'S P602 Signal GEN. DN-2 7KHz
Adjustment
SCREW Osilloscope MONO Bar
Location of Adjustment Parts Observation Waveform
MAIN PCB Horizontal Axis : 0.1mS/DIV
Vertical Axis : 0.1V/DIV
MAIN PCB PARTS SIDE
PY09
PY05
Y/C
BOARD
P602
···
RC HEAD
DECK A'S
To Next Page
Loading...
Need help?
General
