Emptying the Dirty Water Tank (8)
A. Ensure the mains plug is removed from the
socket before emptying the Dirty Water Tank
(8).
B. Once the dirty water has reached the ‘MAX’
mark, the Dirty Water Tank (8) must be
emptied.
C. Lift the Dirty Water Tank (8) up clear of the Spot
Washer. Remove the Dirty Water Tank Lid (10)
and pour out the contents.
D. Rinse the Dirty Water Tank (8) out with warm
water and replace the Dirty Water Tank Lid (10)
before refitting the tank back into the Spot
Washer.
NOTE The Spot Washer will automatically stop
vacuuming water once the Dirty Water Tank (8) is
at the MAX mark.
Cleaning & Maintenance of Your Spot Washer
WARNING! Always disconnect the spot washer from the mains power supply
before cleaning.
• Empty both water tanks after use ensuring that the Dirty Water Tank (8) has
been cleaned out as described above.
• Wipe the outside of the main body with a clean, soft cloth that has been soaked
in warm water and gently wrung out.
• If there is any stubborn dirt or grime, apply a small amount of a gentle kitchen
detergent to the cloth and wipe the area until it is clean. Thoroughly rinse the
cloth and wipe the area again until no detergent residue remains.
• Do not submerge the appliance in water or any other liquids.
To Next Page
Loading...
Need help?
General