Automatically Cleaning the Flexible Hose (7)
1. Remove the Multitool (1) from the Flexible Hose (7) and attach the Hose
Cleaning Attachment (19) to the end of the hose in place of the Multitool (1) as
shown below:
2. Ensure the Dirty Water Tank (8) is empty and fill the Clean Water Tank (13)
with water.
3. Press the On/Off Switch (6) to power up the Spot Washer and let the water
flow through the Hose Cleaning Attachment (19) and into the hose to clean it.
4. Run the Spot Washer until the water in the Clean Water Tank (13) has run out
and/or the hose is clean.
5. Remove the Hose Cleaning Attachment (19) once the hose has been cleaned.
NOTE There is intentionally a hole in the Hose Cleaning Attachment (19).
Storing Your Spot Washer
• Rotate the Adjustable Cable Tidies (14) on the back of the Spot Washer
outwards and wrap the Mains Cable (15) around them.
• DO NOT store the Spot Washer with water in either tank – rinse the tanks out
and allow to thoroughly dry before storage.
• Store the Spot Washer in a cool, dry place away from direct sunlight.
Technical Specification
To Next Page
Loading...
Need help?
General