3. Fill the tank with warm water (max. 40⁰C) as
shown left, ensuring that the water level is not
above the ‘MAX’ mark (arrowed) on the side of
the tank:
In hard water areas it is strongly recommended that distilled/purified
water is used to avoid calcium build up which may damage the Spot Washer.
4. Screw the filling cap back on, turn the tank the correct way up and replace the
Clean Water Tank (13) into the spot washer.
DO NOT overfill the tank as this will cause a spillage/leakage.
DO NOT operate the Spot Washer with an empty clean water tank.
Preparing the Carpet/Upholstery for Cleaning
WARNING! DO NOT
use this Spot Washer as a dry vacuum cleaner as this
will damage the appliance.
Before cleaning, dampen a white cloth and rub the cloth gently over a small test
area on the carpet or upholstery to be cleaned and check for any colour bleeding.
If the cloth remains clean, it should be safe to continue.
Using Your Spot Washer
1. Ensure the Dirty Water Tank (8) is in place.
Remove the Mains Cable (15) from the
back of the Spot Washer by rotating the
Adjustable Cable Tidies (14) inwards as
shown right and then remove the Mains
Cable (15):
NOTE rotate the Adjustable Cable Tidies
(14) outwards before winding the mains
cable back onto the Spot Washer after use.
To Next Page
Need help?
General