KOR-6LBR5S_7
»O
peration procedure
This section includes useful information about oven operation.
1. Plug power supply cord into a 230V 50Hz power outlet.
2. After placing the food in a suitable container, open the oven door and put it on the glass tray.
The glass tray and roller guide must always be in place during cooking.
3. Shut the door. Make sure that it is firmly closed.
4. Set required programme and time, then press Start.
5. Once cooking is complete take care removing container as it will be hot.
WATTAGE OUTPUT CHART
•
The power-level is set by pressing the Power button. The chart shows the display, the power level and the percentage of power.
Press Power button Power level (Display) Approximate Percentage of Power
once P-HI 100%
twice P-80 80%
3 times P-60 60%
4 times P-40 40%
5 times P-20 20%
The oven light turns on while the oven is working.
The oven door can be opened at any time during
operation. The oven will automatically shut off.
Each time a button is pressed, a BEEP will sound to
acknowledge the press.
The oven automatically cooks on full power unless set to a
lower power level.
The display will show nothing when the oven is plugged in,
press and hold the Eco pad until display is turned on and
beep sounds.
When the Stop/Clear button is pressed during the oven
operation, the oven stops cooking and all information
retained. To erase all information press the Stop/Clear
button once more. If the oven door is opened during the
oven operation, all information is retained.
If the Start button is pressed and the oven does not operate,
check the area between the door and door seal for
obstructions and make sure the door is closed securely. The
oven will not start cooking until the door is completely
closed or the program has been reset.
1
2
3
4
5
6
7
Make sure the oven is properly installed and plugged
into the electrical outlet.
DESUK_KOR-6LBR5S(영).indd 7 15. 5. 22. 오후 3:17
To Next Page
Loading...
Need help?
General
