14
OPERATION
This section includes useful information about oven operation.
1. Plug power supply cord into a standard 3 pronged 15 Amp, 120V AC 60Hz power outlet.
2. Place the food in a suitable container.
3. Open the oven door and put the food on the glass tray. (The glass tray and roller guide must
always be in place during cooking.)
4. Close the door firmly.
WATTAGE OUTPUT CHART
• Pressing the POWER pad sets the power-level. The chart shows the display, the power level and the
percentage of power.
• The oven light is on only when the microwave
oven is operating.
• The oven door can be opened at any time during
operation by touching the door release button on
the control panel. The oven will automatically
shut off.
• Each time a pad is touched, a BEEP will sound
to acknowledge the touch.
• The oven automatically cooks on full power
unless set to a lower power level.
Make sure the oven is properly installed and
plugged into the electrical outlet.
• The Display will show “:0” when the oven is
plugged in.
• Time Clock returns to the present time when the
cooking time ends.
• When the STOP/CLEAR pad is touched during
the oven operation, the oven stops cooking and
all information is retained. To erase all
information (except the present time), touch the
STOP/CLEAR pad once more. If the oven door
is opened during the oven operation, all
information is retained.
• If the START pad is touched and the oven does
not operate, check the area between the door
and door seal for obstructions and make sure
the door is closed securely. The oven will not
start cooking until the door is completely closed
or the program has been reset.
Power Level (Display) Approximate Percentage of Power
Touch POWER pad,
Once the Touch
POWER P-HI 100%
9 P-90 90%
8 P-80 80%
7 P-70 70%
6 P-60 60%
5 P-50 50%
4 P-40 40%
3 P-30 30%
2 P-20 20%
1 P-10 10%
0 P-0 0%
To Next Page
Loading...
Need help?
General
