Note.
• If an active signal is not present for about 30 minutes, the set will automatically turn to ST-BY mode.
Adjustment of Time
2. Setting the Wake up time / Program
• Move to Wake Up in the Function menu.
• Select the Wake Up to “On”.
•
Set the Wake up time and Program in the same way as
above for the Clock. The set will turn on at the selected time.
3. Set up of Off Time
• Move to Off Timer in the Function menu.
• Select Off Timer to “On”.
•
Set the
Off
time in the same way as above for the Clock. The set will turn off at the selected time.
4. Sleep Mode
• By pressing the “SLEEP” button on the remote controller
repeatedly, you can select one of the following settings:
Sleep Timer: Off => 15 => 30 => 45 => 60 => 75 => 90
=>105 => 120 => Off.
• The set will turn off after the time you select.
Note.
• Confirm the Time is set. The Wake up time is only available when the Time is set.
• If adjusted once, the On-time continues to operate every day unless you cancel setup or you turn the AC power off.
• It is a convenient method to wake you up in the morning.
Note.
•
This function is very convenient since the TV automatically turns off at the fixed time.
• On/Off time setup is erased if you turn the AC power off.
Note.
• Manually set clock is not memorized any more when TV is AC off.
•
If the clock setting is not done, you can set the clock by setting the “Clock Pr” to the channel which has Text Signal. The present time of
Text channel will be automatically set up. If the clock setting is done already, the clock doesn’t changed by doing like up.
1. Manual clock setting
• Move to Clock in the Function menu.
• Press the “ ▶“ button to set the Clock.
• Place the cursor to Hour / Minute with “◀/▶”
buttons.
• Set the Hour / Minute with the “▼/▲”buttons.
• Place the cursor to Clock with “◀/▶” buttons and
then press the “MENU” button to complete.
To Next Page
Loading...
Need help?
General