4–22 FRONT
12.Finish the welding areas.
• Use a hammer and dolly to even out the brace
wheelhouse for a close fit with the surface of the
wheelhouse.
13.Apply the sealer.
• Apply the sealer to the matching and overlapped
surface.
14.Apply the undercoat.
• Undercoat to the inside of the front, rear wheel-
house and longitudinal.
15.Apply the paint.
CAUTION
• Ventilate when spraying paint. Most paint contains
substances that are harmful if inhaled or swal-
lowed.
Read the paint label before opening paint con-
tainer.
• Avoid contact with skin. Wear an approved res-
pirator, gloves, eye protection and appropriate
clothing when painting.
• Paint is flammable. Store in a safe place, and
keep it away from sparks, flames or cigarettes.
16.Coating the anti-rust agents.
• Coating the anti-rust agents to the end of front
panel side and the door hinge areas.
17.Install the related parts.
• Clean the passenger compartment.
• Windshield, cowl and wiper.
• Wiring harness, instrument panel and related
parts.
• Carpet, trims and weatherstrip.
• Door.
• Fender and hood.
• Radiator grill, bumper and others.
• Install in the reverse order in which they were re-
moved.
18.Check and adjust.
• Check the door for proper installation and opera-
tion.
• Check clearances and level differences.
• Check the hood locking and unlocking condition.
• Check all operation.
• Check for water leaks in the passenger compart-
ment.
NOTE: Use specified check sheet for operation
check properly.
To Next Page
Loading...
Need help?
General
