Dahua DHI-ITC413-PW4D-IZ3 User Manual

Installation and Configuration Manual
21
4 System Configuration
Configuring the Software
4.1.1 Device initialization
The Camera is delivered uninitialized by default. You need to initialize it, and change its password
before further operations.
Before initialization, make sure that both PC IP, and device IP are on the same network segment,
otherwise it might fail to enter the initialization page.
Step 1 Set IP address, subnet mask, and gateway of PC, and device respectively.
 If there is no router in the network, distribute IP address of the same segment.
 If there is router in the network, configure the corresponding gateway, and subnet mask.
The IP address is 192.168.1.108 by default.
Step2 Use ping ***. ***. ***. *** (device IP address) to check whether network is connected.
Step 3 Open browser, enter the IP address of the Camera in the address bar, and then press the Enter
key.
Device initialization
Step 4 Enter and confirm the password.
 The new password must consist of 8 to 32 characters, and contain at least two types from
upper case, lower case, number, and special characters (excluding ' " ; :, and &).
 If you want to change your password again, go to Setting > System > Account >
Account.

Dahua DHI-ITC413-PW4D-IZ3 Specifications

General

Brand	Dahua
Model	DHI-ITC413-PW4D-IZ3
Category	Digital Camera
Language	English