Installation and Configuration Manual
I
Foreword
Disclaimer
In actual use, you can calculate the arming data by Project Design Tool according to the device model,
or send emails to R&D personnel for arming data. The tool calculates the data as if there is a sufficient
amount of illumination by default. If the illumination of the site is poor, the data from the on-site test
will not reach the value calculated by the tool. So the test results from the on-site test should be chosen
over the results from the tool.
Intelligent detection data is closely related to the installation scenario, light, and other factors. When
the installation scenario and light are poor, the intelligent detection data can be improved by adjusting
the scenario and adding illuminators. When the scenario and light are better, the detection effect might
still be somewhat reduced. The test results from the on-site test should be chosen.
Safety Instructions
The following signal words might appear in the manual.
Indicates a medium or low potential hazard which, if not avoided,
could result in slight or moderate injury.
Indicates a potential risk which, if not avoided, could result in
property damage, data loss, reductions in performance, or
unpredictable results.
To Next Page
Loading...
Need help?
General
